Royston Cycling Club - Club Forum
You are not logged in. Would you like to login?
Membership of the forum is restricted to Royston Cycling Club members, i.e. having a current paid-up club subscription.
Guests may post to the Open Forum (under General Discussion section)
** From 4/4/21 rides are in groups of six, following social distancing. Please post below if you intend to ride, or email the club account. **
Please read the Club Rides pages on the website to see which ride suits you. For commonly used routes see the Route Bank
As the Forum is available for anyone to read, please be careful about posting your personal data, e.g. address, phone number, etc.
** From 4/4/21 rides are in groups of six, following social distancing. Please post below if you intend to ride, or email the club account. **
Please read the Club Rides pages on the website to see which ride suits you. For commonly used routes see the Route Bank
As the Forum is available for anyone to read, please be careful about posting your personal data, e.g. address, phone number, etc.
1 of 1- JohnM
- Member
Offline - Registered: 15/9/2014
- Posts: 321
Wanted A Head Stem for 11/4" diameter Steerer Tube
About 8-10 cm long. Most A-Head Stems are for standard 11/8" streerer (fork) tubes. This is 11/4" dia. model I'm looking for is wanted for an old Cannondale MTB. As far as I am aware only Giant MTBs and Canyon bikes come with 11/4" steerer tubes as standard. The Handlebar clamp will be for 31.8 mm or 25.4 mm diameter handlebars. Please PM me if you have anything for sale? Thanks
Last edited by JohnM (14/12/2020 12:53 pm)